Construction Companies in Massachusetts: What Changes Outside Boston

Ask three construction companies in Massachusetts what your project will involve and you can get three different answers, each of them right for some other town. The state building code is the same in Pittsfield and Provincetown. Everything around it changes at the town line, including the energy code your town adopted, the Conservation Commission, the Board of Health if you are on septic, the historical commission, and on the coast, the flood map. We sort out those local layers first, then design and build to them.

Why construction companies in Massachusetts plan town by town

Massachusetts has 351 cities and towns, and permits are issued by the community where the work happens. Every building official enforces the same state building code, 780 CMR. Its tenth edition took effect on October 11, 2024 and became the only code in effect on June 30, 2025. So the rulebook is shared. The fee schedule, the application portal, and the list of boards that have to sign off before the building inspector will are all local.

That is why a useful quote from general contractors in Massachusetts starts with your address, not your wish list. Picture the same 16 by 20 foot rear addition in two towns. On a septic lot near a pond, it may need a Board of Health review and a wetlands filing before anyone pulls a building permit. On a city lot two blocks from the common, it may need a historic commission hearing instead. Same drawing, different project.

Two rules hold everywhere. Each municipality sets its own permit fees, so the state cannot tell you what yours will be. And a permit lapses if work has not started within 180 days of issue, unless the building official grants a written extension. We schedule around that window so a permit is not sitting idle while the crew is still on another job.

For the details of the state process, our guides to Massachusetts building permits and the Massachusetts building code go further. This page is about what changes once you leave Boston. For Boston projects, see our Boston home page.

Base, Stretch or Specialized: your town picks the energy code

The Department of Energy Resources (DOER) keeps a running list of which energy code every municipality has adopted. On October 27, 2026 the count was 241 municipalities on the Stretch Code, a figure that does not include towns that also adopted the Specialized Code, and 61 on the Specialized Code. Measured by population, 58.91 percent of residents live in a Stretch Code community, 33.76 percent in a Specialized Code community and 7.32 percent in a Base Code community.

Towns have reasons to adopt the higher codes. Stretch Code adoption is a requirement for Green Community designation and its grants, and Specialized Code adoption is a requirement for becoming a Climate Leader Community.

In practice the map is a patchwork. Danvers, Fall River, Foxborough, Lynnfield, North Reading, Raynham, Somerset and Wilmington are on the Base Code. Pittsfield and Springfield have been on the Stretch Code since 2011, Duxbury since 2017 and Plymouth since 2021, and Barnstable’s took effect July 1, 2026. Newton and Wellesley have been on the Specialized Code since January 1, 2024, Worcester and Salem since July 1, 2024, and Hingham since January 1, 2026. Canton has adopted it with an effective date of January 1, 2027.

Energy codes set standards for insulation, heating, cooling, lighting and other parts of a building that affect energy use. A house designed for a Base Code town may need a different wall, window or heating plan one town over. We confirm the code with the local building department before design starts, because changing it after drawings are done means redrawing. Our Massachusetts energy code guide explains the three levels.

Wetlands review before you dig

Wetlands are found from the coast to the Berkshires, and the Wetlands Protection Act covers more than the swampy part of a lot. It protects land subject to flooding (100-year floodplains), the riverfront area, and land under ponds, streams and the ocean. The law regulates house construction, additions, decks, driveways, regrading and vegetation removal in those areas.

Locally, the Conservation Commission runs the process. It is a volunteer board of three to seven members, and MassDEP oversees it and hears appeals. If you want to work in a resource area, or within 100 feet of a wetland, MassDEP’s advice is to contact the commission before you start. That 100 foot band is the buffer zone.

The steps are predictable. If you are not sure the rules apply, you can file a Request for Determination of Applicability. If the commission decides the work will alter a resource area, you file a Notice of Intent with a plan showing the resource areas, the buffer zone and how you will protect them, and you pay a fee. The commission visits the site, holds a public hearing and issues an Order of Conditions, which approves the project with conditions or denies it.

More than 100 communities have their own wetlands bylaws on top of the state law. Groton’s bylaw, first adopted in 2000 and replaced in 2015, goes beyond the state act. Salem has a local wetlands ordinance too. A building contractor in Massachusetts who skips the conservation office can end up redesigning after the fact.

Septic towns, Title 5 and the bedroom count

In towns and neighborhoods without sewer, the septic system sets limits that a building permit will not. Title 5 sizes a single-family system by bedrooms, at 110 gallons per day per bedroom with a 330 gallon minimum. So the number of bedrooms on your plans is a septic question as much as a design one.

Title 5 defines a bedroom as a private room meant mainly for sleeping, with at least 70 square feet of floor, a window, electrical service and ventilation, and a minimum ceiling height. Living rooms, dining rooms, kitchens, halls, bathrooms and unfinished cellars do not count.

Even with no new bedrooms, any expansion that needs a building permit triggers a look at the system. If the design flow does not go up, MassDEP requires an assessment that locates the tank, the leach field and the reserve area, so the new work does not land on top of them. Boards of Health may adopt rules stricter than Title 5, so we start with the local health agent.

Historic districts and demolition delay

Massachusetts has more than 200 local historic districts. Each is created under Chapter 40C by a two-thirds vote of the city council or town meeting. Inside one, a locally appointed commission reviews changes to exterior features visible from a public way. An addition, for example, goes to a public hearing and needs the commission’s certificate before work proceeds. Interiors are not reviewed, and many bylaws exempt items such as storm windows, air conditioners and paint color.

National Register listing is different. The Massachusetts Historical Commission says it does not limit a private owner’s choices unless state or federal money or permits are involved or a local rule applies. The state has over 900 National Register districts.

Outside local districts, many towns use demolition delay. In Plymouth, demolishing a structure 75 years or older needs a Historic Commission application first, and a building found preferably preserved can be delayed up to 12 months. Groton’s bylaw covers buildings 75 years or older and allows a delay of up to 18 months. Duxbury’s bylaw reviews partial as well as total demolition of structures 75 or more years old. Old house renovation contractors in Massachusetts need to know these thresholds before tearing off an ell or a porch.

Coastal towns and flood maps

On the South Shore, the North Shore, the Cape and the South Coast, the FEMA flood map comes before the floor plan. The state Office of Coastal Zone Management notes that Massachusetts sets minimum construction standards for coastal areas, covering new buildings, additions, substantial improvements, septic systems and seawalls. CZM also points out that careful design can go beyond those minimums and lower flood insurance costs. We check the Flood Insurance Rate Map panel for the lot before design.

The maps change. FEMA issued revised maps for Essex and Norfolk Counties effective July 8, 2025. Barnstable County’s countywide map dates to July 16, 2014, and the Plymouth County map cited in Duxbury’s zoning bylaw is dated July 6, 2021. Several towns layer their own rules on top: Duxbury has a Flood Hazard Areas Overlay District, and Salem adopted a Coastal Resilience Overlay District in July 2024.

Housing stock by region

The houses themselves change as you cross the state, and so does the work. These are Census figures from the 2020 to 2024 American Community Survey.

  • In New Bedford, 52.1 percent of housing units were built before 1940, and in Salem, 51.0 percent.
  • Fall River has 33.7 percent of its units in three and four unit buildings, and Worcester 24.9 percent.
  • In Barnstable, 67.1 percent of units were built between 1960 and 1999.
  • Plymouth has 28.7 percent of units built in 2000 or later.
  • Carlisle is 93.2 percent single-family detached houses.

A pre-war two-family in a mill city, a 1970s Cape house on septic and a newer colonial in a growing South Shore town call for different plans. That variety is a big part of home remodeling in Massachusetts.

Licenses and contract protections

Massachusetts licenses the construction supervisor who runs most building work. Massachusetts issues unrestricted, one and two family, and specialty licenses. For work on an existing owner-occupied home of one to four units, the contractor must also be registered as a Home Improvement Contractor. Contracts over $1,000 have to be in writing. A deposit cannot exceed one third of the contract price, or the cost of special-order materials if that is higher. Owners who win a judgment against a registered contractor and cannot collect can apply to the Guaranty Fund for up to $25,000. Our contractor license guide and home improvement contractor guide explain how to check both.

What we build across the state

As a construction company in Massachusetts working outside the city as well as in it, we take on:

Where we work

See the towns we serve, or contact us with your address and a few lines about the project. We will tell you which local boards are likely to be involved before we talk about price.

Services available statewide

Cities and towns we serve

Inner suburbs

Central Massachusetts

Western Massachusetts

South Shore

Merrimack Valley

North of Boston

North Shore

MetroWest

South Coast

Cape Cod & Islands

Frequently asked questions

Are building permit fees the same everywhere in Massachusetts?

No. The state code lets each municipality set its own fee schedule, so the same project can cost a different amount to permit one town over. Once issued, a permit lapses if work has not started within 180 days, unless the building official grants a written extension.

How do I find out which energy code my town uses?

DOER publishes a table of all 351 municipalities with the date each one adopted the Stretch or Specialized Code. Danvers, Fall River and Foxborough are still on the Base Code. Duxbury has been on the Stretch Code since July 1, 2017. Newton moved to the Specialized Code on January 1, 2024. Canton has adopted the Specialized Code with an effective date of January 1, 2027.

There is a stream behind my house. Can I still build an addition?

Often yes, but the Conservation Commission comes first if the work is in a resource area or within 100 feet of a wetland. If you are not sure the rules apply, you can file a Request for Determination of Applicability. If the commission finds the work will alter a resource area, you file a Notice of Intent, and after a site visit and public hearing the commission issues an Order of Conditions or denies the project.

Can I add a bedroom if my house is on septic?

Ask the Board of Health before you design it. Title 5 calculates design flow at 110 gallons per day per bedroom, with a 330 gallon minimum for a single-family house, so a new bedroom raises the flow the system has to handle. Title 5 counts a room as a bedroom if it is private, meant mainly for sleeping, at least 70 square feet, and has a window, electrical service and ventilation. Towns can set stricter local rules.

My house is in a National Register district. Does that limit what I can change?

Not by itself. The Massachusetts Historical Commission says that without state or federal involvement, such as federal permits or funding, and without a local rule like a local historic district, National Register listing does not limit how an owner handles the property. A local historic district is a different matter, because its commission reviews exterior changes.

What licenses should a Massachusetts general contractor have?

The person supervising structural work should hold a Construction Supervisor License, either unrestricted or one and two family. For work on an existing owner-occupied home with one to four units, the company must also be registered as a Home Improvement Contractor. Contracts over $1,000 must be in writing, the deposit is capped at one third of the price or the cost of special-order materials, and the state Guaranty Fund can pay up to $25,000 on an unpaid judgment against a registered contractor.

Sources

Facts on this page were last checked against these sources on November 16, 2026.

  1. Mass.gov BBRS, Tenth edition of the MA State Building Code 780 (accessed 2026-11-16)
  2. 780 CMR 105.5, Expiration of permits (via Cornell LII) (accessed 2026-11-16)
  3. 780 CMR 109.2, Fee schedule (via Cornell LII) (accessed 2026-11-16)
  4. Mass.gov DOER, Massachusetts building energy code adoption by municipality (counts and population shares as of October 27, 2026) (accessed 2026-11-16)
  5. Mass.gov DOER, Municipal energy code list (CSV, November 3, 2026) (accessed 2026-11-16)
  6. MassDEP, Protecting wetlands in Massachusetts (accessed 2026-11-16)
  7. MassDEP, Repairs and new construction for Title 5, frequently asked questions (accessed 2026-11-16)
  8. 310 CMR 15.203, System sewage flow design criteria (via Cornell LII) (accessed 2026-11-16)
  9. 310 CMR 15.002, Definitions, bedroom (via Cornell LII) (accessed 2026-11-16)
  10. Massachusetts Historical Commission, There's a difference (local historic districts and National Register districts) (accessed 2026-11-16)
  11. Mass.gov CZM, StormSmart Coasts, Who to contact and what to do before building or rebuilding (accessed 2026-11-16)
  12. Federal Register, FEMA final flood hazard determinations including Essex and Norfolk Counties, MA (effective July 8, 2025) (accessed 2026-11-16)
  13. U.S. Census Bureau, ACS 2020-2024 5-year, B25034 Year structure built (accessed 2026-11-16)
  14. U.S. Census Bureau, ACS 2020-2024 5-year, B25024 Units in structure (accessed 2026-11-16)
  15. Plymouth Demolition Delay Bylaw (archived official page) (accessed 2026-11-16)
  16. Groton Historical Commission, Chapter 125 Demolition Delay (accessed 2026-11-16)
  17. Town of Duxbury Historical Commission, Demolition Delay Bylaw 609 (accessed 2026-11-16)
  18. Town of Duxbury, Zoning Bylaws amended through 2025 (Sec. 402 Flood Hazard Areas Overlay District) (accessed 2026-11-16)
  19. City of Salem, Flood Hazard Overlay and Coastal Resilience Overlay District project page (accessed 2026-11-16)
  20. Federal Register, FEMA final flood hazard determinations, Barnstable County, MA (effective July 16, 2014) (accessed 2026-11-16)
  21. Town of Groton, Master Plan inventory and assessment report (wetlands protection bylaw) (accessed 2026-11-16)
  22. Mass.gov, Learn about different Construction Supervisor Licenses (accessed 2026-11-16)
  23. Mass.gov, HIC contractor resources (accessed 2026-11-16)
  24. Mass.gov, Home improvement contract sample language (accessed 2026-11-16)

Ready to start your project?

Free, no-pressure estimates in Boston and across Massachusetts.