When a house needs more than a room
There is a point where remodeling one room at a time stops making sense. We usually see it when an owner brings us in for a kitchen and we find that the panel is full, the drain lines are original cast iron, the walls have no insulation, and the bathroom upstairs leaks into the kitchen ceiling. Doing the kitchen means opening walls that will have to be opened again in two years for everything else.
The houses where this comes up most in Boston:
- Triple-deckers in Dorchester, Roxbury, East Boston and Southie, where three units share one stack, one roof and often one tired foundation
- Victorian and Colonial Revival single-families in Jamaica Plain, Roslindale and Hyde Park with original plaster and knob-and-tube wiring still live in places
- South End and Charlestown rowhouses that were divided, combined and divided again over a century
- Postwar capes and colonials in West Roxbury that have never had a real update
What a whole-home project with us can include:
- Interior demolition, down to studs and joists where needed
- Structural changes: removing bearing walls, new beams and posts, reinforcing sagging floors
- New layouts, including moving kitchens and baths or adding a bathroom
- New electrical service and wiring, plumbing and heating or heat pump systems, by licensed trades
- Insulation and air sealing as walls and ceilings come open
- Kitchens, bathrooms, flooring, trim, doors, stairs and paint
Whole home remodeling Boston: the order of work
A gut renovation follows a sequence, and most of the expensive mistakes come from doing things out of order.
Investigation comes first. We open small test holes, look at the basement framing, trace the plumbing and wiring, and note what has to be tested for lead or asbestos. This is also when we measure the house for the architect or our own design team.
Design and permitting come next. Plans get drawn and stamped, and the Long Form permit application goes in. Asbestos testing results come back during this stage so abatement can be scheduled.
Then hazardous materials work. Asbestos abatement happens before general demolition, by a licensed abatement contractor after the state notice period. Lead-safe containment goes up wherever painted surfaces will be disturbed.
Demolition follows. We gut to the agreed line, separating out what is being saved, such as trim, doors, mantels or stair parts, and hauling debris.
Rough work comes after that: structural framing, then plumbing, heating and ductwork, then electrical. Each trade gets its rough inspection before anything is covered.
Next is insulation and air sealing, then drywall or plaster.
Finishes close out the job: flooring, cabinets, tile, trim, paint, fixtures and appliances, then final inspections from each trade and the building inspector.
Permits for a whole-house project in Boston
Boston whole home renovations are almost always Long Form permit work, because the City reserves that permit for alterations that change the structure or use of a building. The application has to include a short and a detailed description of the work, an estimated project cost, design plans stamped by a Massachusetts registered engineer or architect, and a certified plot plan. Contractors also submit their license, insurance certificate, workers’ compensation affidavit, a signed contract with the owner and safety affidavits.
The permit goes through zoning review. If the plans do not conform to the property’s zoning, the next step may be the Zoning Board of Appeal, which adds time. Houses in a historic district need Landmarks Commission approval, and work within 100 feet of a park or parkway needs Parks and Recreation approval. Boston will not issue the permit until it has those approvals, and it is up to the applicant to get them.
Homeowners can pull a Long Form permit only for an owner-occupied one or two family house where they are doing the work themselves. In a building of three or more units, a licensed contractor has to do it. Once the permit is issued, work has to start within six months, and beginning before it is issued can bring double fees or a violation. Plumbing, gas and electrical work each get their own permit from licensed trades.
Massachusetts runs on the tenth edition of the State Building Code, which became the only code in effect on June 30, 2025. It is built from 2021 International Code Council model codes, including the International Existing Building Code, and a Massachusetts Residential Code chapter based on the 2021 International Residential Code.
Interior demolition: Boston gut renovations
Most of the demolition we do is interior: plaster and lath, ceilings, old kitchens and baths, partition walls, flooring layers. It is the dirtiest part of the job and it is where the house reveals what you are really dealing with. Interior demolition done carefully also saves money later. Cutting plaster cleanly at the line where it is staying, and protecting the floors you plan to refinish, means less patching.
Full or partial demolition of a structure is a separate process in Boston. A demolition permit application requires shut-off notices from every utility, a Dig Safe reference number, a letter from a pest control contractor covering treatment before and after the demolition, a licensed builder with insurance and workers’ compensation paperwork, review by the City’s Environmental Services Division, and Article 85 demolition delay approval from the Boston Landmarks Commission.
Article 85 review applies to all buildings at least 50 years old in Boston, along with buildings Downtown, in the Harborpark area or in a Neighborhood Design Overlay District. That covers most of the housing stock we work on. Staff decide within 10 calendar days of a complete application whether the building is significant. If it is, a public hearing is scheduled within 30 days, and the applicant has to present alternatives to demolition. Designated landmarks go through a separate process.
On the state side, the Construction Supervisor License system includes a Specialty demolition license that covers demolition only. Demolition contractors, Boston or elsewhere in the state, who also offer to rebuild should hold an unrestricted or one and two family license as well.
Asbestos and lead before anything comes down
Older Boston houses carry both. You plan for them, rather than discover them halfway through demolition.
MassDEP lists the places asbestos turns up in buildings of every age: decorative plaster, heating system insulation, resilient flooring, joint compound, mastics, roofing and siding. Before abatement or removal of asbestos-containing material, Massachusetts requires notice to both MassDEP and the Department of Labor Standards at least 10 working days ahead of time, and the Department of Labor Standards licenses the contractors who do the removal. MassDEP’s separate construction and demolition notification does not apply to residential buildings with fewer than 20 units, but the asbestos notice still does when asbestos is being removed.
We treat any pre-1978 Boston house as having lead paint until testing shows otherwise. Massachusetts requires paid work in that housing to be done by a licensed lead-safe renovation contractor when it disturbs more than 6 square feet of painted surface per room inside or 20 square feet outside, with a certified supervisor on site at all times while the work is going on. On a gut renovation that is every room. It shapes how we set up containment, how debris leaves the house and how the house is cleaned before anyone moves back in.
Systems: wiring, plumbing and heat
A whole-house job is the right time to replace systems that are hard to reach once the walls are closed.
Electrical work in Massachusetts has to be done by a licensed master or journeyman electrician, and the state’s electrician board considers it a violation for a licensed electrician to connect wiring installed by someone unlicensed. For a gut renovation that usually means a new service, a new panel and new wiring throughout. Plumbing and gas work likewise has to be done by a licensed master or journeyman plumber or gas fitter, under a permit from the local inspector. Old galvanized supply lines and cast iron drains are usually replaced while they are exposed.
Heating is where the decisions get bigger. Many owners use a gut renovation to move off an old boiler to heat pumps, or to add central air through new ductwork. The ductwork and line sets have to be planned in the framing stage, not added after drywall.
Energy code, insulation and Mass Save
Boston is one of the Massachusetts municipalities that has adopted the Specialized Energy Code. All three levels of the state energy code start from the 2021 International Energy Conservation Code with Massachusetts amendments, and they set standards for insulation, heating, cooling, lighting and other parts of a building that affect energy use. We plan insulation and air sealing for every wall, ceiling and floor we open, and confirm the energy code requirements with the building department during permit review.
Open walls are also the cheapest time to insulate. Mass Save, sponsored by the state’s utilities, advertises 75 to 100 percent off approved insulation and air sealing improvements, and no-cost upgrades for income-eligible residents. We help owners check what applies before the walls close. Our insulation and drywall page covers that work in more detail.
Hiring whole home remodeling contractors in Boston
Boston whole home remodeling contractors can look alike on paper. On a project this size, the contract and the people matter more than the price on page one.
- Find out who will supervise the job day to day and ask for that person’s Construction Supervisor License. For a whole-house remodel it should be the unrestricted or one and two family license, not a specialty license.
- If you will live in the home and it has one to four units, the contractor must be registered as a Home Improvement Contractor, and the registration number goes on the first page of the contract.
- The contract must lay out the work, materials, start and completion dates and a payment schedule in dollars. Massachusetts caps a deposit at one third of the contract price, unless special-order materials cost more, and the contractor cannot demand final payment before the work is complete to everyone’s satisfaction.
- Ask who the licensed electrician, plumber and gas fitter are, and verify them with the state boards.
- Ask for the lead-safe renovation license and who handles asbestos testing and abatement.
- Ask how allowances and change orders work. On a gut renovation, the contract should say how hidden conditions get priced once the walls are open.
What drives the cost of a whole-house renovation
We do not publish a per-square-foot figure for this work, because the condition of the house matters more than its size. The main drivers:
- How far the demolition goes, and how much of the original house is being saved
- Structural changes and what the engineer requires
- Asbestos abatement and lead-safe work practices
- Electrical service size, plumbing replacement and the heating and cooling system
- Insulation and air sealing to meet the energy code
- Number and level of kitchens and baths
- Zoning relief, historic review or Article 85 timing
- Number of units, access and parking on a tight city street
Where we work
We take on whole-house projects across Boston, from Charlestown and the South End to Dorchester, Jamaica Plain, Roslindale and West Roxbury. Planning a whole home renovation? Greater Boston, MA projects outside the city are covered on our whole-home renovation across Massachusetts page. If you want one team for design and construction, read about our design-build process, and when you have a house in mind, contact us.
How a whole-home renovation project works with us
Call or request an estimate
Tell us what you need and roughly when.
On-site visit
We look at the space, measure and talk through options.
Written estimate
A clear scope, price and schedule, line by line.
Permits & build
We file permits, do the work, pass inspections and walk it through with you.
Whole-Home Renovation across Massachusetts
See our whole home remodeling massachusetts page for work outside Boston.
- Whole House Remodeling Arlington MA: Clean Heat, Permit Budgets and Old Houses
- Newton Whole Home Luxury Remodel: Planning a Full Renovation
Whole-Home Renovation questions
Do we have to move out during a whole-home renovation?
For a true gut renovation, yes. With the electrical, plumbing and heat all disconnected at some point, and lead-safe containment on every floor in an older house, there is no safe or comfortable way to live in it. For phased multi-room work you can often stay in one part of the house while we work in another.
What permit does a gut renovation need in Boston?
A Long Form permit, because the work changes the structure. The application needs stamped design plans, a certified plot plan and a description and estimated cost of the work, and it goes through zoning review. If the property is in a historic district or within 100 feet of a park or parkway, the Landmarks Commission or Parks Department has to sign off before Inspectional Services issues the permit.
Does Boston's demolition delay apply to interior demolition?
The City's Article 85 pages describe review of building demolition and do not address interior-only gutting. A gut renovation that keeps the structure standing usually runs under the Long Form permit. If any part of the building is coming down, we ask the Landmarks Commission about Article 85 before we file.
Who designs a whole-home renovation?
Most gut renovations need an architect or engineer anyway, since a Long Form permit requires stamped plans. Some owners hire an architect first and bring us in to price and build. Others want one team from design to finish, which is what our design-build service is for.
Are there rebates for insulating during a renovation?
Mass Save, the program run by the state's utilities, advertises 75 to 100 percent off approved insulation and air sealing improvements, with no-cost upgrades for income-eligible households. Check eligibility before the walls are closed, because the walls are easiest to insulate when they are open.
Can we keep the original woodwork and floors?
Often. We protect or remove and store trim, doors, mantels and stair parts before demolition, and patch and refinish original floors. In a pre-1978 house any work that disturbs painted trim falls under the Massachusetts lead-safe renovation rules, so that is built into the plan.
Sources
Facts on this page were last checked against these sources on November 14, 2026.
- City of Boston, How to get a Long Form permit (accessed 2026-11-14)
- City of Boston, How to get a demolition permit (accessed 2026-11-14)
- City of Boston Landmarks Commission, Article 85 demolition delay (accessed 2026-11-14)
- Mass.gov, MassDEP asbestos, construction and demolition notifications (accessed 2026-11-14)
- Mass.gov, Lead-safe renovation for homeowners (accessed 2026-11-14)
- Mass.gov, Massachusetts building energy code adoption by municipality (accessed 2026-11-14)
- Mass.gov, Massachusetts building energy codes (accessed 2026-11-14)
- Mass.gov, Tenth edition of the MA State Building Code 780 (accessed 2026-11-14)
- Mass.gov, Learn about different Construction Supervisor Licenses (accessed 2026-11-14)
- Mass.gov, Home improvement contract sample language (required contract terms) (accessed 2026-11-14)
- Mass.gov, Electricians consumer fact sheet (accessed 2026-11-14)
- Mass.gov, Plumbers and gas fitters consumer fact sheet (accessed 2026-11-14)
- Mass Save, Insulation and air sealing (accessed 2026-11-14)