Bathroom Remodeling Boston: Showers, Tile and What Goes Behind It

Bathroom remodeling Boston homeowners ask us about tends to begin with a soft spot in the floor by the tub, or grout that will not stay white, or a fan that hums but moves no air. The tile is what you see. What decides whether a new bathroom lasts is the layer behind it, and the duct above it. We gut, rebuild and finish bathrooms across Boston, with licensed plumbers and electricians on the permits and waterproofing done before a single tile goes up.

Bathroom remodeling Boston houses really need

Every bathroom we open in this city tells a story about the house. A lot of them are the same few stories.

In triple-deckers in Dorchester, Roxbury and Southie, the bathrooms are stacked one above the other, small, and often wedged between the kitchen and a back bedroom. The cast iron stack runs through all three, and the floor around the toilet has seen decades of slow leaks. In Victorians and Queen Annes in Jamaica Plain and Roslindale, the original bathroom was carved out of a bedroom or a closet sometime after the house was built, so the plumbing takes odd routes and the floor framing has been notched to make it fit. Brownstones in the South End and Back Bay have baths tucked into the middle of the floor plan with no window at all. And condo baths in Brighton or Charlestown come with a board that wants to know exactly what is going through the shared walls.

The bath remodeling Boston homeowners hire us for covers a wide range:

  • Gut renovations down to the studs and subfloor
  • Tub-to-shower conversions, walk-in showers and curbless showers
  • Soaking tubs and tub replacements, including cast iron removal from upper floors
  • Vanities, toilets, fixtures, mirrors, storage niches and heated floors
  • Exhaust fans with real ductwork to the outside
  • Accessible bathrooms with blocking for grab bars, wider doorways and zero-threshold entries
  • Primary suites when a bathroom grows into a bedroom or closet

The shower is a waterproofing job first

Tile and grout are not waterproof. Water gets through grout lines, wicks into whatever is behind them and sits there. In the old days that was a mortar bed over a lead or tar paper pan, and in many Boston houses we still tear out shower pans that were built that way 60 or 70 years ago. Those can last a long time when they were done well. The ones we see failing usually had the pan cut or nailed through, or no slope under the pan, so water pooled at the drain.

Today we build showers as a continuous waterproof assembly. The floor gets a sloped base so water heads for the drain, then a bonded waterproof membrane that ties into the drain flange and runs up the walls. Walls get cement board or foam board with the same membrane system over the seams, corners, niches and valve penetrations. We flood test the shower pan before tile, which means plugging the drain and leaving water in it long enough to prove nothing leaks. Then the tile goes on.

A few details that separate showers that last from showers that do not:

  1. The membrane system has to match the drain. Mixing brands at the drain is where leaks start.
  2. Niches need a slight slope on the bottom so water does not sit in them.
  3. Benches are framed or formed solid and waterproofed like the floor, not built out of lumber and covered in tile.
  4. Glass doors and panels get their mounting points planned before tile so we are not drilling through the membrane in random places.

Ventilation: the fan that actually clears the mirror

Most of the bathroom mold we see in Boston comes from moisture with nowhere to go. Lots of older houses have a fan that dumps into the attic or into a closed joist bay, or no fan at all, relying on a window that nobody opens in January.

Massachusetts builds one and two family houses under a Residential Code that adopts the 2021 International Residential Code with state amendments. The model code sets minimum bathroom exhaust at 50 cubic feet per minute for a fan that runs when you switch it on, or 20 cubic feet per minute for one that runs continuously. It also says exhaust air must go outdoors, and specifically not into an attic, soffit, ridge vent or crawl space. We check the details against the current Massachusetts amendments with the inspector on each job.

What that means in practice: a properly sized fan, a short, smooth duct run with as few bends as we can manage, insulated where it passes through cold attic space so condensation does not run back down, and a wall or roof cap with a damper. We often put the fan on a humidity sensor or timer switch, because the EPA’s advice is simple: run the fan or open a window when you shower, and keep indoor humidity below 60 percent, ideally between 30 and 50 percent.

Bathroom renovation Boston permits: Short Form or Long Form

The City of Boston considers a bathroom renovation to be permit work when it means removing and replacing a toilet, tub or sink, adding or changing electrical work, or installing metal exhaust. If you are renovating the existing room and nothing structural changes, the building permit is a Short Form. Once you enlarge the bathroom, move or add a doorway, or cut in a new window, it becomes Long Form work with stamped plans.

The trades file their own permits. Boston issues plumbing, electrical and sheet metal permits separately, and only to a contractor with a valid Massachusetts trade license. At the state level, the plumbing board is blunt about it: only a licensed master or journeyman plumber, with a permit from the local plumbing inspector, can perform plumbing work in your home, and permits are issued only to licensees. The electrician board says the same about electrical work. It also recommends ground fault circuit interrupters in bathrooms and anywhere else electrical products meet water.

Two Short Form rules worth knowing: the work must begin within six months of the permit being issued, and the licensed contractor has to be present for the inspection at the end. If your building is in a historic district and the job touches the outside, such as a new window or a vent through the front wall, Landmarks approval may be needed, and Inspectional Services will not go get it for you.

Custom bathroom remodeling: Boston’s small baths, interior baths and glass

Boston bathrooms are small. A five by seven foot room with a tub along the back wall is about as typical a Boston bathroom as it gets. You can make it feel twice as big without moving a wall:

  • A wall-hung vanity or toilet frees up floor you can see, which reads as space
  • A frameless glass panel instead of a curtain or framed door lets light reach the back wall
  • A niche recessed into the stud bay takes shampoo bottles off the tub ledge
  • A pocket door can rescue the swing space of a door that hits the vanity

Interior baths in brownstones and condos have no window to work with. The 2021 IRC normally asks for 3 square feet of window glass in a bathroom, half of it openable, but it lets you skip the window if the room has artificial light and an exhaust system that vents straight outdoors. That exception is what makes most of those baths legal, and it is why the fan and duct matter so much there.

Glass also has a code rule of its own. Under the model code, glazing in walls or enclosures around tubs and showers counts as a hazardous location when its bottom edge is less than 60 inches above the floor, unless it is more than 60 inches away horizontally from the water’s edge. Shower doors, glass panels and a window beside the tub often fall into that zone, and they need safety glazing.

Lead, old tile and what is under the floor

Bathrooms in pre-1978 homes are full of painted surfaces: window trim, door casings, wainscoting, the radiator. Massachusetts requires that paid work in pre-1978 housing that disturbs more than 6 square feet of painted surface in a room be done by a licensed lead-safe renovation contractor, with a certified supervisor on site the entire time the work is in progress. A bathroom gut hits that threshold almost every time.

Under the floor we tend to find one of three things: an old mortar bed several inches thick, layers of vinyl over plywood over boards, or framing that was cut years ago for a drain and never reinforced. Mortar beds are heavy and slow to remove but usually sit on solid framing. Cut joists get sistered or headed off before anything else happens, because a cracked tile floor over a weak joist is a repair you will pay for twice.

Accessible and aging-in-place bathrooms

Plenty of people want to stay in their Boston house as they get older, or need a bathroom a parent can use safely. The work is mostly about thinking ahead:

  • Solid blocking in the walls at grab bar heights, even if the bars go in later
  • A curbless shower with a linear drain, so there is nothing to step over
  • A handheld shower on a slide bar, with the valve reachable from outside the spray
  • Wider doorways where the framing allows, and lever handles instead of knobs
  • Comfort-height toilets and a vanity with knee space if a seat is needed

A curbless shower on a wood-framed floor means getting the shower area lower than the rest of the room. Sometimes that is done by recessing the subfloor between joists, sometimes by building up the rest of the bathroom floor. We look at the framing first and tell you which way your house allows.

Choosing bathroom contractors: Boston questions to ask

When you compare bathroom remodelers, Boston or suburban, the questions that matter are not about tile samples. They are these:

  • What waterproofing system will you use for the shower, and do you flood test the pan?
  • Where will the fan vent, and how long is the duct run?
  • Who is the licensed plumber and electrician, and will they pull their own permits?
  • Is your company registered as a Home Improvement Contractor? In Massachusetts that is required for work on owner-occupied homes of one to four units, and building permits carry a notice that people who use unregistered contractors have no access to the state’s Guaranty Fund.
  • Does the written contract list the materials, the start and completion dates, and a payment schedule in dollars? Massachusetts requires all of that for home improvement contracts over $1,000.
  • For a pre-1978 house, do you hold a lead-safe renovation license?

A good contractor answers these without hesitating, and puts the answers in writing.

What changes the price of a bathroom remodel

We do not quote a bathroom by the square foot, because two rooms of the same size can be very different jobs. What drives the number:

  • Whether the toilet, tub, shower and vanity stay where they are or move
  • Tub-to-shower conversion versus a straight replacement
  • What is under the floor and behind the walls once it is open
  • Tile size and pattern. Large-format porcelain and intricate mosaics both take more labor than standard tile
  • Glass: a curtain rod, a framed door or custom frameless panels
  • Fan ductwork, especially in interior baths and top-floor units
  • Heated floors, steam showers or a second sink
  • Lead-safe work practices and condo access rules

Your estimate breaks those out line by line. For tile and flooring choices see our flooring and tile page. If the new bath is going in a lower level, start with our basement finishing page.

Where we work

We remodel bathrooms across Boston, from Charlestown and East Boston to Mattapan, West Roxbury and Hyde Park. For work in other cities and towns, see our bathroom remodeling in Massachusetts page. If your bathroom is part of a bigger project, our kitchen remodeling and whole-home renovation teams work from the same schedule. Contact us to set up a visit.

How a bathroom remodeling project works with us

  1. Call or request an estimate

    Tell us what you need and roughly when.

  2. On-site visit

    We look at the space, measure and talk through options.

  3. Written estimate

    A clear scope, price and schedule, line by line.

  4. Permits & build

    We file permits, do the work, pass inspections and walk it through with you.

Bathroom Remodeling across Massachusetts

See our bathroom remodel massachusetts page for work outside Boston.

Bathroom Remodeling questions

Does a bathroom remodel in Boston need a permit?

Yes, in nearly every case. Taking out and replacing a toilet, tub or sink, or doing electrical or exhaust work, is permit work in Boston. The building side is a Short Form permit when nothing structural changes and a Long Form permit when it does. The plumber, electrician and sheet metal contractor each pull their own permit, and only licensed trades can apply.

Can I do the plumbing in my own bathroom?

Not in Massachusetts. The state's plumbing board says only a licensed master or journeyman plumber, with a permit from the local plumbing inspector, may perform plumbing work, and permits are issued only to licensees. Fixing a leaky faucet or clearing a clog does not need a permit, but replacing the faucet does.

Where should my bathroom fan vent?

Outdoors, through a wall or the roof. The model residential code Massachusetts adopts says exhaust air may not be dumped into an attic, soffit, ridge vent or crawl space. A fan that blows into the attic just moves the moisture problem upstairs, where it shows up as mold on the roof sheathing.

Can you turn my tub into a walk-in shower?

Usually. We remove the tub, move the drain and valve, slope the floor to the drain, waterproof the whole shower and tile it. In a second-floor bathroom we check the joists first, since a curbless shower often means lowering the floor framing slightly to get the slope.

Do I need a window in a remodeled bathroom?

No. The 2021 IRC asks for 3 square feet of window, half of it openable, but allows an exception when the bathroom has artificial light and an exhaust fan that vents directly outdoors. Most interior condo baths in Boston rely on that exception.

Is the mold behind my tub surround something I can clean myself?

The EPA says a homeowner can generally handle a moldy area smaller than about 10 square feet. If it is larger, or the wall is soft or stained from a long leak, the problem is in the framing and the wall needs to come out.

Sources

Facts on this page were last checked against these sources on November 14, 2026.

  1. City of Boston, Renovate a bathroom or kitchen (accessed 2026-11-14)
  2. City of Boston, How to get a Short Form permit (accessed 2026-11-14)
  3. Mass.gov, Plumbers and gas fitters consumer fact sheet (accessed 2026-11-14)
  4. Mass.gov, Electricians consumer fact sheet (accessed 2026-11-14)
  5. Mass.gov, Tenth edition of the MA State Building Code 780 (adopts the 2021 IRC with Massachusetts amendments) (accessed 2026-11-14)
  6. International Code Council, 2021 International Residential Code, Chapter 3 Building planning (R303.3, R308.4.5) (accessed 2026-11-14)
  7. International Code Council, 2021 International Residential Code, Chapter 15 Exhaust systems (M1501.1, Table M1505.4.4) (accessed 2026-11-14)
  8. U.S. EPA, A brief guide to mold, moisture and your home (accessed 2026-11-14)
  9. Mass.gov, Lead-safe renovation for homeowners (accessed 2026-11-14)
  10. Mass.gov, HIC contractor resources (accessed 2026-11-14)
  11. Mass.gov, Home improvement contract sample language (required contract terms) (accessed 2026-11-14)

Planning a bathroom remodeling project?

Free, no-pressure estimates in Boston and across Massachusetts.