Replacement windows Burlington MA houses need, by style
Burlington’s housing grew fast and all at once. The Historical Commission’s history counts 3,250 residents in 1950 and 19,473 in 1965, as Route 128 replaced farms with subdivisions. Census Bureau estimates for 2020 to 2024 date 24.0 percent of units to 1940 through 1959 and 32.3 percent to 1960 through 1979. Each common house type from those decades brings its own window list.
- Ranches. One story, long walls, often a big picture window in the living room flanked by smaller units. The picture window is usually the most expensive single opening on the house and the one most owners want to keep large.
- Capes. Small windows in the gable ends and dormers on the second floor. Dormer windows are hard to reach, so staging and access drive the cost more than the window does.
- Split-levels and raised ranches. The lower level sits half below grade, so there are more windows close to the ground. Those sills see snow, splash-back and rot first.
- Garrisons and colonials. A regular pattern of double-hungs on two floors, which suits a full-house replacement in one visit.
Houses built since 2000, almost a quarter of the stock, tend to need fewer full replacements. Their typical complaints are fogged insulated glass or worn balances, which can sometimes be fixed without new units.
Lead rules come first on most Burlington houses
About 62 percent of Burlington’s units were built before 1980. For window work that matters more than almost anything else. The EPA renovation rule treats window replacement in pre-1978 housing as covered work regardless of how little paint is disturbed, and Massachusetts requires a licensed lead-safe renovation contractor for it.
In practice that means plastic sheeting inside and out, careful removal of stops and casing, no dry scraping, HEPA vacuuming and a cleaning check at each opening. It adds labor to every window. When two bids differ widely, ask both contractors for their lead-safe license and how they contain and clean each room. Our lead paint law guide covers the details.
Basement windows Burlington MA owners ask about
Split-levels and houses with full basements raise a second question: what to do with the small windows in the foundation. There are two very different jobs here.
The first is a straight swap. Old steel or wood hopper windows in a poured or block wall are replaced with new units in the same opening. That is a quick job and a good one for comfort.
The second is an egress window, usually because the owner wants to finish the basement or add a bedroom down there. Under the 2021 model residential code that Massachusetts builds on, an emergency escape opening needs at least 5.7 square feet of net clear opening, at least 24 inches of clear height and 20 inches of clear width, and a sill no more than 44 inches above the floor. A window below grade needs an area well of at least 9 square feet with at least 36 inches of projection, and a well deeper than 44 inches needs a permanent ladder or steps. Cutting a bigger opening in the foundation is structural work, so it goes on the building permit with its own details.
Because an egress well means digging next to the foundation, we also ask the Building Department whether Burlington’s groundwater rules, Zoning Bylaw 5.1.6, approved September 28, 2022, have any bearing on the lot. On most lots they will not, but the question costs nothing to ask early. Our basement finishing page explains the rest of that project.
Stretch Code, ratings and rebates
Burlington adopted the Stretch Code effective July 1, 2019, and has not moved to the Specialized Code, per the DOER list dated November 3, 2026. For an addition or a new house, windows are part of the energy compliance package reviewed with the plans. For a replacement in an existing opening, we confirm with the department what product information it wants on the application.
ENERGY STAR publishes its window criteria by climate zone, and it is a reasonable baseline when comparing quotes. On rebates, the Mass Save windows page in November 2026 listed $75 per window toward ENERGY STAR Most Efficient units, available only after a Home Energy Assessment confirms the existing windows are single pane. Whether you qualify depends on your utility account and the program’s current rules.
Permits, doors and the two-week rule
Permits are issued by the town through the Building Department at 25 Center Street, and all applications go in online. The department asks applicants to plan a minimum of two weeks for application, plan review and issuance, and it requires a new application if the general contractor changes. Window work needs a Construction Supervisor License, with the window and siding specialty as the minimum, and HIC registration on owner-occupied homes of one to four units.
Doors follow a slightly different rule. The state chart says door replacement needs a permit when it is an exit door or a safety issue, while installing a door in a new opening always needs one. Sliders to a deck and the front entry are the usual candidates on Burlington ranches.
Condos and townhouses
Buildings with five or more units hold 22.6 percent of Burlington’s housing, and attached single family homes another 3.4 percent. In those buildings the association usually sets the window style, color and sometimes the manufacturer. Get its written approval before ordering, since custom windows are rarely returnable.
Next steps
Any home improvement contract over $1,000 must be in writing. Our windows and doors page explains installation methods, the Massachusetts windows page covers statewide rules, and the window cost guide discusses pricing. For the town overview, see our Burlington page. Then contact us with your address, the year built and a count of the windows you want to replace.
How a windows & doors project works with us
Call or request an estimate
Tell us what you need and roughly when.
On-site visit
We look at the space, measure and talk through options.
Written estimate
A clear scope, price and schedule, line by line.
Permits & build
We file permits, do the work, pass inspections and walk it through with you.
More about replacement windows boston and windows & doors across Massachusetts, or see every service we offer in Burlington.
Frequently asked questions
Do replacement windows need a permit in Burlington?
Yes. The state chart lists window installation and replacement as building permit work with a Construction Supervisor License and, for owner-occupied homes of one to four units, HIC registration. Burlington takes the application online through its Building Department.
Can I add an egress window to my Burlington basement?
Often, if the wall and grade allow it. Cutting a larger opening in a foundation wall is structural work with its own permit, and a habitable room below grade needs an escape opening that meets the code size, height and sill limits, plus a large enough window well. We check the foundation and the yard before promising one.
Are basement windows Burlington MA houses already have worth replacing?
Small hopper windows in a poured or block foundation are often single glazed and leak air. Replacing them in the same opening is a simple job. Turning one into an egress window is a different and larger project.
Will I get a rebate for new windows in Burlington?
Maybe. In November 2026 the Mass Save windows page offered $75 per window toward ENERGY STAR Most Efficient units, but only after a Home Energy Assessment confirms single-pane windows. Eligibility depends on your utility and the program rules, so book the assessment first.
My windows are in a condo. Who decides?
Usually the association. About 22.6 percent of Burlington units are in buildings of five or more units, and those buildings typically control exterior appearance and sometimes the window product itself.
Sources
Facts on this page were last checked against these sources on November 17, 2026.
- Town of Burlington, Building Department (Wayback Machine archive, October 5, 2025) (accessed 2026-11-17)
- Town of Burlington, Historical Commission (Wayback Machine archive, August 14, 2026) (accessed 2026-11-17)
- Massachusetts DOER, Municipal Energy Code List (CSV, November 3, 2026) (accessed 2026-11-17)
- Mass.gov, HIC contractor resources (what work needs an HIC, CSL or building permit) (accessed 2026-11-17)
- US EPA, Renovation, Repair and Painting program for contractors (accessed 2026-11-17)
- Mass.gov, Department of Labor Standards, Lead-safe renovation for contractors (accessed 2026-11-17)
- International Code Council, 2021 International Residential Code, Chapter 3 Building Planning (emergency escape openings) (accessed 2026-11-17)
- ENERGY STAR, Residential windows, doors and skylights key product criteria (accessed 2026-11-17)
- Mass Save, Windows rebates and offers (accessed 2026-11-17)
- US Census Bureau, ACS 2020 to 2024 5-year, B25034 year structure built (accessed 2026-11-17)
- US Census Bureau, ACS 2020 to 2024 5-year, B25024 units in structure (accessed 2026-11-17)