Whole House Remodeling Arlington MA: Clean Heat, Permit Budgets and Old Houses

Whole house remodeling Arlington MA owners plan today runs into a rule most Massachusetts towns do not have. Arlington is part of the state's fossil fuel free demonstration program, and its bylaw reaches major renovations as well as new houses. That one fact shapes the mechanical plan, the electrical service and the kitchen. Add houses that are mostly prewar and a fee schedule charged per trade, and a gut renovation needs a plan before it needs a dumpster.

Whole house remodeling Arlington MA plans start with the heat source

In most Massachusetts towns, a gut renovation lets the owner choose between gas and electric for heat, hot water and cooking. In Arlington, a large enough project may not have that choice. State law set up a demonstration project, run by the Department of Energy Resources, in which no more than ten cities and towns may require new construction and major renovation projects to be fossil fuel free. Arlington is one of them. DOER issued the town its project acceptance letter on February 21, 2024, and the bylaw took effect 90 days later, on May 21, 2024. It grew out of the 2020 Clean Heat Bylaw, which a 2023 Special Town Meeting updated and re-enacted.

The word that matters is “major.” Whether a given remodel is a major renovation depends on its scope, so we put that question to Inspectional Services while the drawings are still rough. If the answer is yes, the design changes in predictable ways:

  • Heat pumps replace the boiler or furnace, which brings decisions about outdoor unit locations and line set routes through old framing.
  • Water heating goes to a heat pump unit or another electric option, which needs floor space and some air volume.
  • Cooking goes electric, usually induction.
  • The electrical service and panel often need an upgrade to carry all of that.

Even when a project falls short of a major renovation, many owners choose the same path because the walls are open anyway. Our whole home renovation hub covers sequencing for gut jobs in general.

The Specialized Code and an existing house

Arlington adopted the state’s Specialized Code on January 1, 2024, after a 2023 Town Meeting vote. The joint information site run by Acton, Arlington and Lexington says that code applies to new construction, where it requires high performance and readiness for all-electric heating and cooling. A remodel of an existing house is reviewed differently, but a new addition or a teardown and rebuild is not a remodel. Our energy code guide explains the state’s three code tiers.

Budgeting the town’s permit fees

Arlington charges per trade, on the estimated cost of each trade’s work. From the town’s fee schedule:

Permit Fee
Building (one and two family, other, demolition) $20 per $1,000 of estimated cost
Mechanical and sheet metal $20 per $1,000
Plumbing and gas $30 per $1,000
Electrical $30 per $1,000
Dumpster or pod $24 flat
Zoning Board of Appeals petition $400

Every permit has a $50 minimum. On a whole house job, the arithmetic adds up: $250,000 of general construction carries a $5,000 building permit, and $40,000 of electrical work carries a $1,200 electrical permit. Fees triple if work begins before a permit is issued, and a re-inspection for work that was not ready costs $50. We carry these as line items in the estimate so they do not surprise anyone.

The exterior is where the historic rules apply

Inside the house, the town’s preservation bodies have no role. Outside, they can. The Arlington Historical Commission reviews exterior changes affecting more than 25 percent of a front or side elevation on buildings listed in its Inventory of Architecturally and/or Historically Significant Properties. A whole house job that adds a dormer, reworks the windows on one face or adds a rear ell that shows from a side street can reach that line.

The Commission’s design principles set out how it judges those changes. Additions and exterior alterations must retain the original character of the property and complement its materials, features, scale and spatial relationships, without impairing the building’s essential form. It also says historic carriage barns, garages and outbuildings should be preserved, which is worth knowing before a plan calls for knocking down an old detached garage.

Seven local historic districts, Avon Place, Broadway, Central Street, Jason/Gray, Mount Gilboa/Crescent Hill, Pleasant Street and Russell, have their own commissions, which review most exterior design changes, including removal of trim.

Gutting a prewar Arlington house

Census estimates for 2020 to 2024 put 47.1 percent of Arlington’s units before 1940 and the median year built at 1945. Gutting those houses usually means plaster on lath and wiring added in layers by different owners. It also means lead. Paid renovation that disturbs paint in a home built before 1978 has to be done lead-safe by a licensed contractor, and in a full gut nearly every painted surface is disturbed.

Two-unit buildings hold 23.9 percent of the town’s units. A whole house remodel of a two-family is really two remodels sharing a basement, a roof and often a stair. Separate services, fire separation between units and a phasing plan that lets one household stay in place are design questions, not afterthoughts.

The Inspectional Services page also links the town’s Tree Protection and Preservation Bylaw, stormwater management rules and wetlands regulations. Large site work, new foundations and additions near trees are where those come up.

An ADU in the same project

The 2024 state ADU law allows one protected use ADU by right in single family zoning in every municipality except Boston, Arlington included. A gut renovation is a natural time to carve out a basement or attic unit. Our ADU law guide explains the limits.

Contracts and licensing

On an owner-occupied home with one to four units, the contractor must be a registered Home Improvement Contractor, and any contract over $1,000 must be in writing. Ask who holds the Construction Supervisor License and which licensed electrician and plumber will pull the trade permits.

For exterior pieces of the job, see our Arlington siding page and Arlington roofing page. The Arlington kitchen remodeling page covers electric cooking in more detail. Then contact us with your address and a rough scope.

How a whole-home renovation project works with us

  1. Call or request an estimate

    Tell us what you need and roughly when.

  2. On-site visit

    We look at the space, measure and talk through options.

  3. Written estimate

    A clear scope, price and schedule, line by line.

  4. Permits & build

    We file permits, do the work, pass inspections and walk it through with you.

More about whole home remodeling boston and whole-home renovation across Massachusetts, or see every service we offer in Arlington.

Frequently asked questions

Does Arlington's fossil fuel free bylaw apply to my gut renovation?

It covers new construction and major renovations. Whether your project is a major renovation depends on its scope, so raise it with Inspectional Services while the design is still on paper. If it applies, plan on electric heat, hot water and cooking from the start.

How are permit fees calculated on a big remodel in Arlington?

Each permit is priced on the estimated cost of its own work. The building permit is $20 per $1,000, electrical and plumbing or gas are $30 per $1,000, and mechanical is $20 per $1,000. Fees triple if work starts without a permit.

Will the Historical Commission review my interior gut?

No. The Commission reviews exterior changes to inventoried buildings, and the district commissions review exteriors in the seven local districts. Interior work becomes their business only when it changes the outside, such as new windows, a dormer or an addition.

Can I add an ADU as part of the remodel?

The 2024 state law allows one protected use ADU by right in single family zoning in every municipality except Boston, so it applies in Arlington. A building permit is still required, and an ADU added during a gut renovation shares the same planning questions about heat and service size.

What should a whole house remodeling contract include?

A written scope and payment schedule, the contractor's Home Improvement Contractor registration, the Construction Supervisor License holder, who pulls each trade permit, and lead-safe work if the house predates 1978. Massachusetts requires a written contract for home improvement work over $1,000.

Sources

Facts on this page were last checked against these sources on November 17, 2026.

  1. Town of Arlington, Clean Energy Future Committee (fossil fuel free bylaw and Specialized Code) (accessed 2026-11-17)
  2. Mass.gov DOER, Municipal fossil fuel free building demonstration project (accessed 2026-11-17)
  3. Towns of Acton, Arlington and Lexington, Energy efficient and fossil fuel free building requirements (accessed 2026-11-17)
  4. Town of Arlington, Schedule of Building Permit Fees (PDF) (accessed 2026-11-17)
  5. Town of Arlington, Inspectional Services (accessed 2026-11-17)
  6. Arlington Historical Commission, FAQs (accessed 2026-11-17)
  7. Town of Arlington, Historic Districts Commission (accessed 2026-11-17)
  8. US Census Bureau, ACS 2020 to 2024 5-year, B25034 year structure built (accessed 2026-11-17)
  9. US Census Bureau, ACS 2020 to 2024 5-year, B25024 units in structure (accessed 2026-11-17)
  10. Mass.gov EOHLC, Accessory dwelling unit FAQs (accessed 2026-11-17)
  11. Mass.gov, Lead-safe renovation for homeowners (accessed 2026-11-17)
  12. Mass.gov, HIC contractor resources (accessed 2026-11-17)
  13. Mass.gov, Home improvement contract sample language (accessed 2026-11-17)

Whole-Home Renovation in Arlington? Let's talk.

Free, no-pressure estimates in Boston and across Massachusetts.